Formwork Waterproofing System
Need to fill & waterproof the formwork holes caused by Z-Bar & Tie-Bar systems? RiveStop is your solution!
A patented elastic rivet with a mechanical waterproofing system specifically designed to SEAL hermetically formwork holes on the concrete walls quickly, permanently, and effectively.
Provides waterproofing reliability and efficiency into the taper tie voids or cast in pipes onto the concrete wall.
Gallery Here
Insert RiveStop into a Rivet Machine
Place RiveStop in the hole to be sealed.
Riveting until pin breaks off.
Weather & Temperature Conditions
Looking back on the walls, engineers and construction supervisors can check very quickly if the RiveStop is inside the hole and installed.
Durable
RiveStop has been tested and certified - designed to seal the hole forever.
Adaptable
Comes in various sizes to suit most applications
Mechanical System
RiveStop ensures a fully closed, permanent and durable seal - providing 100% Waterproofing.
Time Saving
Install with a manual or electric riveter and each hole will be sealed & fully waterproof within 3-5 seconds!
Clean
It does not stain the concrete or wall, no drops on the ground. No other concrete additives are needed.
Check at a glance
Looking back on the walls, engineers and construction supervisors can check very quickly if the RiveStop is inside the hole and installed.
No Margin of Error
Anyone can install RiveStop - no need for any training. There is no way that RiveStop can be done half-right or half-wrong.
No need for further finishing
No other finishing to the wall is needed, but if the engineering requests a special finishing, additional product could be also used.
The Riveting Action takes approximately 3-5 seconds per hole (with an electric riveter even faster), allowing you to save up to 90% on labor costs compared to other existing sealing/ patching systems on the market.